Deciphering Jack Analysis Bar by Bar ll

Today's whole chart. Carryover is in up sequence at a wait after just assigning T1. Notice how the OB on b78 did not receive the "advance one peak" treatment. B77 wait caused a squish.Therefore the OB is considered a XR instead and makes b78 the first measurable bar possible to assign a first P1 after the PP4 on b76. http://screencast.com/t/yItaS1qPOP3s

 

BM REV and Ba on b3. http://screencast.com/t/E3MkJIKw2I2

 

Ok check this out.B4 is a stitch that went higher than the BM on top of b3 but than closes below so no BM REV.Notice this does not allow a RTL to be draw.So this is how a RTL can then not be draw for the rest of this sequence.So i believe you can't have a BO T1 in this sequence. http://screencast.com/t/Hk7c9odp

 

Another sequence can't draw the rlt. http://screencast.com/t/u307pmYMca5

 

Thru b26 update.B17 was Bc.PP4 on b19.Ab on b24. PP3 on b26.Don't believe its a BO T1 on b26. http://screencast.com/t/lSrkbsdJ

 

B32: Ab ?
thx

 

Can you please spell out the bars that got you to B32 Ab so i know how you got it?

 

Having seen your posted no gap chart using Sierra,
I noticed that my NT no gap chart isn't always printing the no gaped bar's highs to lows correctly.
Hence I didn't have a "W" on bar 27 but a P1. and going forward from there,
this led me to an Ab on bar.
many thx

 

Can you post your chart for these bars please.

 

Should B28 be a "W" rather than a P1 ?
thx
Edit: sorry. No the 27 "SQ" would make 28 measurable..